Many Eclypse analyzers come with a High Voltage (HV) Stimulus Key on the front or rear panel of the unit. When this key is in the “ON” position, the internal HV stimulus power supplies are enabled and the analyzer is capable of testing with HV Stimulus. When the key is in the “OFF” position, the internal HV power supplies are physically locked out to prevent any stimulus output greater than 28 volts. This is a safety lock-out device for when the analyzer is used in environments where high voltage is hazardous.
Last updated on September 20th, 2022
The alignment function (found in ELITE under TOOLS on the menu bar) provides users with a method to verify the analyzer is operating within proper tolerances. Unlike ELITE “Self Test”, alignment focuses on the accuracies of stimulus output of all power supplies and measurement accuracies of all devices and ranges. Alignment requires the use of an external Alignment Tool (supplied with each analyzer) that has been calibrated (verified) by a qualified Metrology lab.
Last updated on September 20th, 2022
The Self Test function (found in ELITE under TOOLS on the menu bar) provides users with a method to verify all analyzer functions are in operating condition. Unlike ELITE “Alignment”, Self Test focuses verifying all features and matrix boards are operating properly. If any part of the analyzer fails to perform correctly, the results of Self Test include steps that an operator can take to remedy the problem.
Last updated on September 20th, 2022
AWTS is an acronym for Automatic Wire Test Set. AWTS is a group of analyzers with set configurations that were designed to meet requirements set by a joint DOD acquisition for deployable common test equipment for the US Air Force, US Navy, and US Marine Corps. For more information concerning AWTS click here.
Last updated on September 21st, 2022
Eclypse recommends that alignment tools be sent to a qualified metrology laboratory at least once a year (annually) to maintain proper analyzer operation. For information on the metrology laboratory used by Eclypse, Click Here.
Last updated on September 21st, 2022
No. Each Eclypse analyzer is supplied with an “alignment tool” that contains precision fixed values. Operators use this tool when performing periodic alignment to validate the analyzer is operating properly. The alignment tool is the only device that requires inspection at a qualified metrology lab to verify the values in the tool are within specified tolerance.
Last updated on September 20th, 2022